GO-DIRECT-MAIN is an RP2040 main board for controlling stage equipment at smaller venues such as small theaters and gymnasiums. It has Ethernet, two RS-485 channels, three isolated switch inputs and two I²C buses for connecting expansion boards.

The image is a rendering of the top side drawn from the design data.
Specifications
| Item | Specification |
|---|---|
| Model | GO-DIRECT-MAIN |
| CPU | RP2040 |
| Flash | 16 MB |
| Input power | 24 V DC |
| Ethernet | WIZ850io (W5500), RJ45 |
| Serial | RS-485 terminals CH1 and CH2 |
| Digital inputs | 3 optocoupler-isolated points (EMERGENCY, UP, D.N) |
| Analog inputs | 3 channels (DMX-SW terminal AD0–AD2) |
| Select outputs | 3 points (DMX-SW terminal SEL0–SEL2) |
| Expansion interfaces | Two I²C buses (machine bus and RD bus) |
| USB | Type-B, program download |
| Setting switches | Two rotary switches (device count and device mode) |
| Button | CPU RESET |
| Boot selection | BOOT MODE jumper |
| Board size | 92 × 87 mm |
Main board pin map
| Function | Channel or signal | GPIO |
|---|---|---|
| Digital input | EMERGENCY | GP6 |
| Digital input | UP | GP7 |
| Digital input | D.N | GP10 |
| Analog input | AD0 | GP26 |
| Analog input | AD1 | GP27 |
| Analog input | AD2 | GP28 |
| Select output | SEL0 | GP13 |
| Select output | SEL1 | GP14 |
| Select output | SEL2 | GP15 |
| CH1 | TX | GP0 |
| CH1 | RX | GP1 |
| CH2 | TX | GP8 |
| CH2 | RX | GP9 |
| Ethernet | MISO | GP16 |
| Ethernet | CS | GP17 |
| Ethernet | SCK | GP18 |
| Ethernet | MOSI | GP19 |
| Ethernet | RESET | GP20 |
| Ethernet | INT | GP21 |
| Machine bus | SDA0 | GP4 |
| Machine bus | SCL0 | GP5 |
| RD bus | SDA1 | GP2 |
| RD bus | SCL1 | GP3 |
| Expansion buses | RST | GP29 |
| Device count switch | X1 | GP22 |
| Device count switch | X2 | GP23 |
| Device count switch | X4 | GP24 |
| Device count switch | X8 | GP25 |
| Device mode switch | X1 | GP11 |
| Device mode switch | X2 | GP12 |
RST is shared by the machine bus and the RD bus. The RD bus is the same I²C bus as the on-board FRAM. AD0 to AD2 and SEL0 to SEL2 on the DMX-SW terminal are 3.3 V signals wired directly to RP2040 pins. GPIO numbers do not specify terminal voltage ratings or physical connector pin numbers.
Expansion boards
| Model | Bus | Function |
|---|---|---|
| GO-DIRECT-CB3 | Machine bus | 3 UP/DOWN relay channels, 6 limit inputs, 3 OCR inputs |
| GO-STAGE-RD8 | RD bus | 8 relay outputs |
| GO-STAGE-SW5 | RD bus | 20 switch inputs, 20 outputs |
Comments
Enter a nickname to leave a comment, or sign in with Google or GitHub.